Surface Protection Issues

Surface Protection Issues

When using adhesive surface protection products on a job site there is always a small risk of adhesive transfer. Improper set up, high temperatures, high visitors, and surpassing the advisable 'remove by' date can all result in problems with carpet masks and films. Following are a few suggestions to keep away from any adhesive transfer.

Always comply with the producer's suggestions when utilizing carpet films. Carpet film usage rankings range from 30 to 60 days. Leaving the film on carpets previous the recommended utilization rating invalidates all producers' warranty.
Use films made in the USA for one of the best warranty protection and highest quality.
Carpet films use either water primarily based or solvent primarily based adhesives. Water based adhesives are simpler to remove if a problem occurs.
By no means set up adhesive carpet protection on wet or damp carpet.
By no means set up adhesive carpet protection over glue down carpet for a minimum of 72 hours to allow the glue to "breathe".
If carpet has been put in over a newly poured cement slab that's not fully cured, keep away from using adhesive carpet protection as it can trap the cement moisture and discolor the carpet.
In cases of utmost heat, shorten the recommended time of application by 50%.
As said on the installation directions of each film producer, there isn't any warranty offered for application on wool carpets.
If the above steps are taken, the chance of any adhesive transfer when utilizing a carpet film is negligible. In the cases the place steps have NOT been adopted, certainly one of these issues may happen: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet where the plastic was used. It is crucial at this step to know the type of adhesive used, water or solvent based.

Water based mostly adhesive film residue simply removes with warm water and might be quickly removed by way of steam cleaning the carpets. Solvent based adhesive residue may additionally be removed via steam cleaning nonetheless it could take more than one cleaning to completely remove the adhesive. Citrus cleaners available at any hardware store can sometimes aid in the removal of solvent based adhesive residue. If further problems persist, contact your local surface protection supplier to debate different potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the next response of the moisture and the chemical compounds in the plastic film. Sadly this situation can only be remedied by removal of the affected space of carpet. This situation occurs most commonly in cases the place users have carpeted over slabs that weren't fully cured.

If you have any issues regarding in which and how to use temporary carpet protection, you can make contact with us at our own webpage.