Surface Protection Issues

Surface Protection Issues

When using adhesive surface protection products on a job site there's always a small risk of adhesive transfer. Improper installation, high temperatures, high site visitors, and surpassing the recommended 'remove by' date can all end in problems with carpet masks and films. Following are a number of suggestions to keep away from any adhesive transfer.

Always follow the manufacturer's recommendations when utilizing carpet films. Carpet film utilization scores range from 30 to 60 days. Leaving the film on carpets past the recommended utilization ranking invalidates all producers' warranty.
Use films made in the USA for the very best warranty protection and highest quality.
Carpet films use either water based or solvent based adhesives. Water based mostly adhesives are easier to remove if a problem occurs.
Never install adhesive carpet protection on wet or damp carpet.
By no means set up adhesive carpet protection over glue down carpet for no less than 72 hours to permit the glue to "breathe".
If carpet has been installed over a newly poured cement slab that isn't fully cured, avoid utilizing adhesive carpet protection as it can trap the cement moisture and discolor the carpet.
In cases of extreme heat, shorten the really helpful time of application by 50%.
As said on the set up directions of each film producer, there is no warranty offered for application on wool carpets.
If the above steps are taken, the prospect of any adhesive switch when utilizing a carpet film is negligible. Within the cases where steps have NOT been adopted, certainly one of these two points could happen: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet where the plastic was used. It will be significant at this step to know the type of adhesive used, water or solvent based.

Water primarily based adhesive film residue simply removes with warm water and will be quickly removed via steam cleaning the carpets. Solvent based mostly adhesive residue may additionally be removed through steam cleaning however it could take more than one cleaning to fully remove the adhesive. Citrus cleaners available at any hardware store can generally aid in the removal of solvent primarily based adhesive residue. If further problems persist, contact your local surface protection supplier to discuss other potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the following reaction of the moisture and the chemicals within the plastic film. Sadly this situation can only be remedied by removal of the affected space of carpet. This situation occurs most commonly in cases where customers have carpeted over slabs that were not fully cured.

If you have any issues pertaining to where by and how to use temporary floor protection, you can get hold of us at our own site.